![]() ![]() I don’t even remember when I last time used ICOM for F-series flashing, it was over a year ago anyway. New original ICOM Next costs around 510 euros, I think that there is no different between it and ENET in reliability. Chinese cloned ICOM’s can be worse than ENET. I meant that ENET is no worse than ICOM, and very very likely original ICOM is no worse than ENET. You can even flash whole car without DHCP server by first flashing the ZGW with ICOM and then flashing the rest with ENET. With ENET you can flash NBT even without DHCP server and with ICOM you can flash ZGW without DHCP server. Fix is the same for both, use DHCP server to assign IP adresses. ![]() ENET can’t flash all ZGW modules and ICOM can’t flash any NBT units (including all other control units in MOST bus like KOMBI, AMP and so on). There are problems with both ICOM and ENET. Router DHCP, Icom DHCP and Windows Ethernet: automatic dhcpįirst of all the ICOM should be configured this way:īMW ICOM or ENET cable: which better for flash This is a customer share of configuration that worked flawless: I use this on multiple ISPI laptops and never had an issue and never needed a router to connect the computer and ICOM to. Then you can program everything without faults. But you do need a DHCP server running on the laptop on the ethernet interface.ġ) Set a static IP on the Ethernet (not wireless) interface – I use 192.168.254.1ģ) Configure DHCP server to listen on the Ethernet interfaceĤ) Click on the buttons to set firewall ports and run as serviceĥ) Connect up your ICOM and it’ll get a DHCP address from the DHCP server no direct connection laptop -> icom.īut you don’t have to use a router. ICOM and computer must be connected through a router with DHCP server enabled. There are good reasons why bmw doesn’t allow programming via wifi Imagine if the wifi connection drops during programming then the car is screwed up. Ista p does not support wifi (wlan) and will not start ista p server if the wifi is enabled on the laptop, only ista p client will open and you cannot select istap server to program. ![]() Why LAN cable connection better than WLAN from rounter to PC:īecause ista P does not support wlan connections. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |